2 m - 16x16 mm Extrusion Enclosure Corner Profile
[G123010_2000]

• 

• Just add aluminum side panels and make an enclosure of whatever size and length you need!
• This enclosure profile is made of clear anodized extruded aluminum. 

2 Methods for Making Instant Enclosures:
Two slots are provided to insert 1.5 mm thick aluminum sheet stock or 1/16" aluminum sheet stock
Panels are held in place by End CAPS screwed into corner extrusion profile

OR
Hardware set can be used to hold aluminum panels from 2 to 5mm thick against the extrusion (see photos) or .080"-.200" thick
END CAPS would finish the enclosure but would not be needed to hold clamped panels in place.

• Channels in the profile corner are designed to be used with M5 self-tapping screws or tapped with an M5 thread for holding front and rear enclosure panels. 
• This profile is used to construct enclosures for mechanical or electrical components.
• Available in 1, 2 or 3 m lengths
• We can custom cut to any length up to 3m for a small charge
• Profile weight is .26Kg/m