These clamping devices are design to work with Isel extrusions and linear motion systems.
|ADJUSTABLE TOGGLE CLAMP |
Made of steel, the Adjustable Toggle Clamp is ideal for holding odd shaped parts. The front screw can be positioned along the T slot while the rear screw adjusts the pressure on the part. Both M6 screws and an M6 T-Slot nut are included with the clamp.
|LOW PROFILE CAM LOCK CLAMP |
This cam clamp is designed for lighter low profile materials such as engraving plastic sheets. The T slot mounting hardware is included.
|HEAVY-DUTY CAM LOCK CLAMP |
Made of black oxidized hardened steel, this clamp will provide up to 2500 N of clamping force with 100 N (22.5 lbf) of actuating force. A rotation of the locking arm will provide a clamp stroke of 4 mm (.15 in). 15 mm (.6 in) high, 32 mm (1.3 in) wide, 107 mm (4.2 in) overall length. Provided with two-hole nut strip and screws to allow mounting to a T-Slot.
|CLAMP BARS |
Made of plated steel, these Clamp Bars are 10 mm (.39 in) high and 20 mm (.8 in) wide. Available in 3 lengths of 125, 175 and 250 mm. To be used with either the cam lock clamps or the pneumatic clamps to make a work holder. Provided with screws and nuts to allow mounting to a T-Slot.
|PNEUMATIC CLAMP |
Made of hardened steel with a black oxide finish, the Pneumatic Clamp is provided with screws and nuts for mounting to the T-Slots and a fitting for 6 mm (.23 in) OD, 4 mm (.15 in) ID plastic pressure tube.
|MANUAL VISES |
These Manual Vises are made of steel with side slots for flexible mounting. The moveable jaws have side guides and the stationary jaws have both horizontal and vertical V-slots for holding round objects. Both jaws have support surfaces for holding flat objects
Configure Your Part
Select Options then Click “Add to Quote”
|Add To Quote|